Dell Insprion 530
Intel Core2 Duo 2.33 Ghz 4GB Ram 300GB HD
Zenwalk 6.4 LiveCD
Primary OS: Win7 Home Premium
*****************************************
Zenwalk runs great. Decided to load on below computer for use as thin client for home office work. This worked out better than I expected.
*****************************************

PowerSpec 4322
Intel Celeron 366 Mhz 256MB Ram 6GB HD
Zenwalk 6.4 Standard
Original OS: Win98 FE

Zenwalk issues resolved:
*****************************************
After my initial Zenwalk installs failed, decided to max out the Ram (was 64MB) and removed Win98. Zenwalk installed successfully.
*****************************************
NE2000 PnP Ethernet Card - was not detected
Edit etc/rc.d/rc.modules adding the below line (taken from DSL LiveCD install)
/sbin/modprobe ne io=0x280 irq=5
Used netconfig to setup IP Address/Gateway
*************************************
3DLabs Permedia2 Video Card - installed, but needed tweaking.
Edit /etc/X11/xorg.conf for Device, Monitor, and Screen Sections.
Device Section: Detected 8MB VideoRam, but only had 4MB, which caused garbage screen buttons.
Monitor Section: Added 1024x786 mode, needed for 800x600 screen limit fix.
Screen Section: Added only 1024x768 mode, needed for 800x600 screen limit fix.
===================================
Section "Device"
Identifier "Videocard1"
VendorName "3DLabs"
BoardName "3DLabs Permedia2"
Chipset "pm2v"
VideoRam 4096
EndSection

Section "Monitor"
Identifier "Monitor1"
Modeline "1024x768_60.00" 78.75 1024 1040 1136 1312 768 769 722 800 +HSync +VSync
HorizSync 31.5-75.0
VertRefresh 40-90
EndSection

Section "Screen"
Identifier "Zenwalk"
Device "Videocard1"
Monitor "Monitor1"
DefaultDepth 24
Subsection "Display"
Depth 8
Modes "1024x768"
EndSubsection
Subsection "Display"
Depth 16
Modes "1024x768"
EndSubsection
Subsection "Display"
Depth 24
Modes "1024x768"
EndSubsection
Subsection "Display"
Depth 32
Modes "1024x768"
EndSubsection
EndSection
================================
**************************************************
Run aslaconf to setup sound.
****************************************************
Citrix XenApp Cleint Receiver
Used netpkg to install gstreamer
Installed XenApp Client
To resolve "SSL Code 61 Error - site trust error", copied Windows Certification (Internet Explorer 8>Tools>Content>Certifications) to /usr/lib/ICAClient/keystore/cacerts
************************************************
Thanks Zenwalk!